![]() ![]() RaspberryPi is a very small, low-cost, single-board open-source computer. As of Oct 2013, it's supposed to have imperfect support for Marlin. In Oct 2013, build of master on osx failed. In Oct 2013, Dan couldn't get it to run gcode files although it's got some nice manual control features. To get going, change baud rate to 250000 and click connect.īeautiful, open source, versions for windows, linux, and mac. In Oct 2013, Dan used it for manual control and entering gcodes, but couldn't get it to send a file. ![]() Printrun is a gcode sender that's supposed to have good support for RAMPS. Suitable for running on low spec gear (eg on Raspberry Pi3), as well as standard desktop/laptop usage. When using a CNC machine, there needs to be a program which sends the gcode created on a computer, to the motor controller which executes the gcode by moving around the motors.Īn alternative G-Code Sender to UGS (below).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |